Mink Trapping Part 10

Spread of Jaws, 4 inches. Occasionally animals free themselves from traps by gnawing their legs off just below the trap jaws, where the flesh is numb from pressure. Various forms of traps have been experimented with to obviate this difficulty. The Webbed Jaws shown above have proved very successful in this respect.

Noting the cross-section of the jaws, as ill.u.s.trated at the left, it is plain the animal can only gnaw off its leg at a point quite a distance below the meeting edges. The flesh above the point of amputation and below the jaws will swell and make it impossible to pull the leg stump out of the trap.

The No. 81 Trap corresponds in size with the regular No. 1 Newhouse.

[Ill.u.s.tration: NEWHOUSE NO. 91 TRAP]

Spread of Jaws--91, 5 1/4 inches; 91 1/2, 6 1/4 inches. The double jaws take an easy and firm grip so high up on the muskrat that he can not twist out. A skunk cannot gnaw out either.

These traps are especially good for Muskrat, Mink, Skunk and Racc.o.o.n.

All parts of the No. 91 except the jaws are the same size as the regular No. 1 Newhouse, while the 91 1/2 corresponds to the regular No. 1 1/2.

[Ill.u.s.tration: NEWHOUSE NO. 1 1/2 TRAP]

Spread of Jaws, 4 7/8 inches. This size is called the Mink Trap. It is, however, suitable for catching the Woodchuck, Skunk, etc.

Professional trappers often use it for catching Foxes. It is very convenient in form and is strong and reliable.

[Ill.u.s.tration: NEWHOUSE NO. 2 TRAP]

Spread of Jaws, 4 7/8 inches. The No. 2 Trap is called the Fox Trap.

Its spread of jaws is the same as the No. 1 1/2 but having two springs it is, of course, much stronger.

[Ill.u.s.tration: NEWHOUSE NO. 3 TRAP]

Spread of Jaws, 5 1/2 inches. This, the Otter Trap, is very powerful.

It will hold almost any game smaller than a bear.

[Ill.u.s.tration: NEWHOUSE NO. 4 TRAP]

Spread of Jaws, 6 1/2 inches. This is the regular form of Beaver Trap. It is longer than the No. 3 Trap, and has one inch greater spread of jaws. It is a favorite with those who trap and hunt for a living in the Northwest and Canada. It is also extensively used for trapping the smaller Wolves and Coyotes in the western stock raising regions.

[Ill.u.s.tration: NEWHOUSE NO. 2 1/2 TRAP]

Spread of Jaws, 6 1/2 inches. In some localities the Otter grows to an unusual size, with great proportionate strength, so that the manufacturers have been led to produce an especially large and strong pattern. All the parts are heavier than the No. 2 1/2, the spread of jaws greater and the spring stiffer.

[Ill.u.s.tration: NEWHOUSE NO. 3 1/2 TRAP]

Spread of Jaws, 5 inches. The above cut represents a Single Spring Otter Trap. It is used more especially for catching Otter on their "slides." For this purpose a thin, raised plate of steel is adjusted to the pan so that when the trap is set the plate will be a trifle higher than the teeth on the jaws. The spring is very powerful, being the same as used on the No. 4 Newhouse Trap. The raised plate can be readily detached if desired, making the trap one of general utility.

[Ill.u.s.tration: NEWHOUSE NO. 21 1/2 TRAP]

Single Spring. Same as No. 2 1/2 but without Teeth or Raised Plate.

No. 31 1/2 NEWHOUSE TRAP.

Single Spring. Same as No. 3 1/2 but without Teeth or Raised Plate.

Spread of Jaws--No. 21 1/2, 5 1/4 inches; No. 31 1/2, 6 1/2 inches.

These Traps are the largest smooth jaw, single spring sizes that are made. Professional trappers will find these especially valuable when on a long trapping line, as they are more compact and easier to secrete than the large double spring traps. The springs are made extra heavy.

Note.--The 21 1/2 is practically a single spring No. 3 and the 31 1/2 a single spring No. 4.

[Ill.u.s.tration: NEWHOUSE NO. 14 TRAP]

Spread of Jaws, 6 1/2 inches. This Trap is the same in size as the No. 4 Beaver, but has heavier and stiffer springs and offset jaws, which allow the springs to raise higher when the animal's leg is in the trap, and is furnished with teeth sufficiently close to prevent the animal from pulling its foot out.

[Ill.u.s.tration: CLUTCH DETACHABLE TRAP]

Clutch Detachable--Trap can be used with or without it.

PATENTED.

Spread of Jaws, No. 23, 5 1/2 inches; No. 24, 6 1/4 inches. The inventor of this attachment claims to have had wonderful success with it in taking Beaver. The trap should be set with the clutch end farthest from sh.o.r.e. The beaver swims with his fore legs folded back against his body, and when he feels his breast touch the bank he puts them down. The position of the trap can be so calculated that he will put his fore legs in the trap, when the clutch will seize him across the body and hold him securely.

[Ill.u.s.tration: NEWHOUSE NO. 4 1/2 TRAP]

In response to a demand for a new model of the Newhouse Trap especially adapted to catching wolves, the manufacturers have perfected a trap which is numbered 4 1/2 and is called the "Newhouse Wolf Trap."

This trap has eight inches spread of jaw, with other parts in proportion, and is provided with a p.r.o.nged "drag," a heavy snap and an extra heavy steel swivel and chain, five feet long, warranted to hold 2,000 pounds. The trap complete with chain and "drag" weighs about nine pounds.

[Ill.u.s.tration: NEWHOUSE NO. 50 TRAP]

Spread of Jaws, 9 inches. This trap is intended for catching small sized Bears. In design it is exactly like the standard No. 5 Bear Trap, only that the parts are all somewhat smaller. Weight, 11 1/4 pounds each.

[Ill.u.s.tration: NEWHOUSE NO. 150 TRAP]

Spread of Jaws, 9 inches. This trap is identical with No. 5 excepting that the jaws are offset, making a s.p.a.ce five-eighths inch between them. This allows the springs to come up higher when the bear's foot is in the trap, and thus secure a better grip. Also there is less chance of breaking the bones of the foot. Weight, 11 1/4 pounds each.

[Ill.u.s.tration: NEWHOUSE NO. 5 TRAP]

Spread of Jaws, 11 3/4 inches. This trap weighs nineteen pounds. It is used for taking the common Black Bear and is furnished with a very strong chain.

[Ill.u.s.tration: NEWHOUSE NO. 15 TRAP]

Spread of Jaws, 11 3/4 inches. To meet the views of certain hunters whose judgment is respected, the manufacturers designed a style of jaw for the No. 5 trap, making an offset of 3/4 of an inch, so as to allow the springs to come up higher when the bear's leg is in the trap. This gives the spring a better grip. Those wishing this style should specify "No. 15."

[Ill.u.s.tration: NEWHOUSE NO. 6 TRAP]

Spread of Jaws, 16 inches. Weight, complete, 42 pounds. This is the strongest trap made. We have never heard of anything getting out of it when once caught. It is used to catch lions and tigers, as well as the great Grizzly Bears of the Rocky Mountains.

[Ill.u.s.tration: BEAR CHAIN CLEVIS AND BOLT]

This cut ill.u.s.trates Bear Chain Clevis and Bolt, intended as a subst.i.tute for the ring on the end of the trap chain, when desired.

With this clevis a loop can be made around any small log or tree without the trouble of cutting to fit the ring. The chain is made five feet long, suitable for any clog, and the prices of bear traps fitted with it are the same as with the regular short chain and ring.

[Ill.u.s.tration: TRAP SETTING CLAMP]